About this product

Polymer80 PF940v2™ 80% Full Size Frame and Jig Kit (Glock® 17/22/24/31/34/35 Compatible) – 3-Pack

Overview

This listing offers the Polymer80 PF940v2™ 80% Full Size Frame and Jig Kit in a three-unit pack, providing a complete foundation for building three full-size pistol frames compatible with Glock® 17, 22, 24, 31, 34, and 35 platforms. Each kit includes an unfinished 80% frame and the necessary jig to complete the frame milling process. Designed for the serious builder, this 3-pack ensures consistent geometry across multiple builds and reduces per-unit cost for volume projects. The PF940v2™ frame is manufactured from reinforced polymer and features an integrated steel rear rail system for enhanced durability. Each unit requires standard hand tools and basic mechanical skills to finish the frame to a functional state.

Features & Specs

• Includes three complete Polymer80 PF940v2™ 80% full-size frames and three corresponding jig kits. Each frame is compatible with Glock® 17, 22, 24, 31, 34, and 35 slide assemblies and internal parts sets.
• Frame material: high-impact, glass-reinforced polymer. Integrated steel rear rail module pre-installed. Adjustable trigger housing pin location accommodates factory and aftermarket triggers. Machined polymer index points for consistent grip placement.
• Jig kit includes: one reusable drilling and milling jig per frame, three drill bits (sizes 2mm, 3mm, 4mm), one 1/8-inch end mill, one cross pin, one 3/32-inch roll pin punch, and one instruction booklet. All jigs are precision-machined for repeatable alignment across all three frames.

Key dimensional specifications: overall frame length 8.15 inches, height 5.60 inches, width 1.30 inches. Trigger guard opening measures 0.80 inches wide by 1.20 inches deep. Magazine well opening measures 0.90 inches wide by 1.10 inches deep. Compatible with standard Glock® 17/22/24/31/34/35 magazines.

Who It’s For

The Polymer80 PF940v2™ 80% Full Size Frame and Jig Kit (Glock® 17/22/24/31/34/35 Compatible) – 3-Pack is intended for intermediate to advanced firearms builders who require multiple identical frames for training, competition, or inventory expansion. This kit is suitable for individuals who already possess basic knowledge of frame finishing, including drilling, milling, and fitting procedures. The 3-pack format is particularly useful for builders who need to maintain consistent ergonomics across several builds or for those who wish to construct frames for multiple calibers within the Glock® 17/22/24/31/34/35 platform. Builders should have access to a drill press or hand drill, a vise, and appropriate safety equipment. This product is not recommended for first-time builders without prior experience with 80% frames.

Shipping & FFL

This Polymer80 PF940v2™ 80% Full Size Frame and Jig Kit does not require shipment to a Federal Firearms License (FFL) dealer because it is not considered a completed firearm under federal regulations. The frame is classified as an unfinished receiver and may be shipped directly to your residence in most states. However, purchasers must verify that possession of 80% frames is legal in their state, county, and municipality. Some states, including but not limited to California, New York, New Jersey, Connecticut, Massachusetts, Washington, and the District of Columbia, have laws restricting or prohibiting the purchase, possession, or completion of unfinished frames. It is the sole responsibility of the purchaser to comply with all applicable federal, state, and local laws prior to ordering. By purchasing this product, you confirm that you are legally eligible to own and complete firearm components and that you will not assemble this frame into a functional firearm in violation of any law. This product is sold as a raw component kit only; no firearm is included. No FFL transfer is required for this item.